DJI Mavic 3 Pro Drone with Fly More Combo & RC - Manual (Page 82)

DJI Mavic 3 Pro User Manual
82
© 2023 DJI All Rights Reserved.
Linking the Remote Controller
The remote controller is already linked to the aircraft when purchased together as a combo.
Otherwise, follow the steps below to link the remote controller and the aircraft after activation.
1. Power on the aircraft and the remote controller.
2. Launch DJI Fly.
3. In camera view, tap
and select Control and then Connect to the Aircraft. During linking,
the status LED of the remote controller blinks blue and the remote controller beeps.
4. Press and hold the power button of the aircraft for more than four seconds. The aircraft
beeps twice after a short beep, and its battery level LEDs blink in sequence to indicate it is
ready to link. The remote controller will beep twice, and its status LED will turn solid green to
indicate linking is successful.
• Make sure the remote controller is within 0.5 m of the aircraft during linking.
• The remote controller will automatically unlink from an aircraft if a new remote
controller is linked to the same aircraft.
• Turn off the Bluetooth and Wi-Fi of the remote controller for optimal video
transmission.
• Fully charge the remote controller before each flight. The remote controller sounds an
alert when the battery level is low.
• If the remote controller is powered on and not in use for five minutes, an alert will
sound. After six minutes, the aircraft automatically powers off. Move the control sticks
or press any button to cancel the alert.
• Fully charge the battery at least once every three months to maintain battery health.