DJI Mavic 3 Pro Drone with Fly More Combo & RC - Manual (Page 38)

DJI Mavic 3 Pro User Manual
38
© 2023 DJI All Rights Reserved.
Hovering
Time The duration of the aircraft hovering time at the current waypoint.
* Before selecting POI for heading or gimbal tilt, make sure there are POIs in the flight route. If a POI is
linked to a waypoint, the heading and gimbal tilt of the waypoint will be reset to toward the POI.
All the settings except camera action can be applied to all waypoints after selecting Apply to
All. Tap to delete the current selected waypoint.
3. POI Settings
Tap POI on the operation panel to switch to POI settings. Use the same method to pin a POI
as used with a waypoint.
Tap the number of the POI to set the altitude of the POI, the POI can be linked to a waypoint.
Multiple waypoints can be linked to the same POI, the camera will point toward the POI
during the Waypoint Flight.
4. Plan a Waypoint Flight
Tap or Next to set parameters for the flight route such as Global Speed, the behavior of
End of Flight, On Signal Lost, and Start Point. The settings apply to all waypoints.
Global Speed The flight speed during the entire flight route. After setting, the speed of
all waypoints will be set to this speed.
End of Flight The behavior of the aircraft after the flight task ends. It can be set to
Hover, RTH, Land, or Back to Start.
On Signal Lost The behavior of the aircraft when the remote controller signal is lost
during flight. It can be set to RTH, Hover, Land, or Continue.
Start Point After selecting the start waypoint, the flight route will be started from this
waypoint to the subsequent waypoints.
5. Perform a Waypoint Flight
• Check the Obstacle Avoidance Action settings in the Settings > Safety page of DJI Fly before
performing the Waypoint Flight. When set to Bypass or Brake, the aircraft will brake and
hover in place if an obstacle is detected during the Waypoint Flight. The aircraft cannot
sense obstacles if the Obstacle Avoidance Action is disabled. Fly with caution.
• Observe the environment and ensure there are no obstacles on the route before
performing Waypoint Flight.
• Make sure to maintain visual line of sight (VLOS) with the aircraft. Press the flight
pause button in an emergency situation.
• When the signal is lost during flight, the aircraft will perform the action set in On
Signal Lost.
• When the Waypoint Flight is finished, the aircraft will perform the action set in End
of Flight.