NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 603)

- Address: The source IP address format to match in dotted-decimal.
- Mask: The bit mask in IP dotted-decimal format indicating which parts of the
source IP address to use for matching against packet content.
• Source L4 Port: Select this radio button to require a packet’s TCP/UDP source
port to match the specified protocol, which you must select from the menu. You
can also select Other from the menu and enter a port number from 0 to 65535.
• Destination IP: Select this radio button to require a packet’s destination IP address
to match the specified IP address. After you select the radio button, use the
following fields to configure the destination IP address match criteria:
- Address: The destination IP address format to match in dotted-decimal.
- Mask: The bit mask in IP dotted-decimal format indicating which parts of the
destination IP address to use for matching against packet content.
• Destination L4 Port: Select this radio button to require a packet’s TCP/UDP
destination port to match the specified protocol. You can also select Other from
the menu and enter a port number from 0 to 65535.
• IP DSCP: Select this radio button to require the packet’s IP DiffServ Code Point
(DSCP) value to match the specified IP DSCP keyword code, which you must
select from the menu. You can also select Other from the menu and enter an IP
DSCP value from 0 to 63. The DSCP value is defined as the high-order 6 bits of
the Service Type octet in the IP header.
• Precedence Value: Select this radio button to require the packet’s IP precedence
value to match the specified number from 0 to 7, which you must select from the
menu. The IP Precedence field in a packet is defined as the high-order 3 bits of
the Service Type octet in the IP header.
• IP ToS: Select this radio button to require the packet’s Type of Service (ToS) bits
in the IP header to match the specified value. The IP ToS field in a packet is defined
as all 8 bits of the service type octet in the IP header. After you select the radio
button, use the following fields to configure the ToS match criteria:
- Bit Value: Enter a two-digit hexadecimal number octet value in the range
from 00 to ff to match the bits in a packet’s ToS field.
- Bit Mask: Specify the bit positions that are used for comparison against the
IP ToS field in a packet.
11. Click the Apply button.
Your settings are saved.
12. To save the settings to the running configuration, click the Save icon.
The following table describes the view-only fields in the Class Summary section.
Main User Manual 603 Configure Quality of Service
Fully Managed Switches M4350 Series Main User Manual