Hand Held Products 7200/UG - Manual (Page 106)

C H A P T E R 7 U S I N G T H E D O L P H I N 7 2 0 0 H O M E B A S E
106 106 106 106
Switch Setting Function
2 FIXED BPS
(DOWN)
Baud rate fixed at 57600
2 PROGRAM
(UP)
Baud rate can be programmed
Figure 19 Configuration Switch Settings for a HomeBase Network
When Switch 2 is in the ‘PROGRAM’ position, the baud rate can be changed using
the following procedure or by using the HomeBase Configuration Utility.
Enter or send the escape and command strings:
<ESC>HHPBn
n is the ASCII number corresponding to the baud rate shown in the table below. For
example, the string <ESC>HHPB6 (which consists of the escape string and the
command B6) would set the baud rate for the network to 19200. No response will be
transmitted back to the host after executing this function.
ASCII Value
of “n”
Selected
Baud Rate
ASCII Value
of “n”
Selected Baud
Rate
0 38400 6 19200
1 38400 7 38400
2 1200 8 57600
3 2400 9 115200
5 9600
Figure 20 Baud Rate per Value of n
Device Selection
Use this command to enable the host device to select a specific Dolphin HomeBase in
the network for communication.
1. Enter or send the escape and command strings:
<ESC>HHPSn
where n is the unit ID of the Dolphin HomeBase being selected
2. The Dolphin HomeBase with the unit ID corresponding to the ID number in the
Device Selection command string will respond with:
<ACK>n
to indicate to the host that it is present. N is the unit ID.
N O T E
The baud rate is stored in
Non-Volatile Memory and is
retained even if the power is
removed from the network.