Hand Held Products 7200/UG - Manual (Page 47)

C H A P T E R 3 D O L P H I N 7 2 0 0 R F H A N D H E L D C O M P U T E R
47 47 47 47
Example 1: To configure WEP using the batch mode, create the keys.txt file
using a text editor as shown:
Sample ASCII keys.txt file for 40-bit encryption where x is the key code:
ASCII
xxxxx
xxxxx
xxxxx
xxxxx
xxxxx
Sample HEX keys.txt file for 128-bit encryption where x is the key code:
HEX
xxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxx
After creating the keys.txt file, copy it to the c:\rf directory and enter:
C:>\WEP BATCH
Result: The WEPOPEN operating mode is automatically set (the WEP mode can be
changed using commands shown later in this document). One of the following
messages will display on the terminal:
Need keys.exe and keys.txt
(if both files are not present)
or
Error(s): Retry
(if error occurred writing to radio card)
or
Done
(if keys successfully set)