Hand Held Products 7200/UG - Manual (Page 88)

C H A P T E R 6 D O L P H I N 7 2 0 0 2 D H A N D H E L D C O M P U T E R
88 88 88 88
1.
Scan Image Screen
Press the ON/SCAN key, aim and release it to take an image. After you scan the
image, the terminal will beep, and the image taken will appear on the screen. If the
image is acceptable, press the ENTER key to save the image and proceed to the next
step. If the image is not satisfactory, press the ON/SCAN key to take a new image.
Repeat as necessary to acquire the desired image and proceed to the next step.
2. The following screen will appear:
3. Place the terminal in the HomeBase to begin transferring the file to your
host computer. Note: You must put the terminal into the HomeBase within 15 seconds
of taking the image. Otherwise, the image will be deleted and you will have to retake the
image.
HomeBase Screen