Hand Held Products 7200/UG - Manual (Page 151)

C H A P T E R 1 0 T R O U B L E S H O O T I N G A N D W A R R A N T Y
I N F O R M A T I O N F O R D O L P H I N 7 2 0 0 T E R M I N A L
151 151 151 151
Resetting The Dolphin Terminal
Under normal circumstances, you should not need to reset the Dolphin terminal.
However, if required, you can reset the terminal with one of the following methods:
1. Perform the “Three Key Reset.”
The Dolphin terminal can be reset by pressing and releasing the “SHIFT”,
“ON/SCAN” and “BKSP” keys. All three keys must be held down and released at
the same time.
2. Press the Reset Switch.
The reset switch is located in the battery compartment of the Dolphin terminal.
Use the tip of an unfolded paper clip (or other similar blunt object) to gently press the
reset switch.
Note: The recess hole for the reset switch may be covered with a small plastic cover.
This cover must be removed and placed back in position after accessing the reset
switch.
3.
Remove the Main Battery.
If the methods described above are not successful, the Dolphin terminal may be reset
by removing the main battery for an extended period of time. The terminal will reset
when the Dolphin’s internal backup battery is completely drained of power. This
process may take up to 5 hours.
Reset Switch