Hansol Multitech Uromat 3000 - Manual (Page 3)

06/00 - 3 of 90 - 0116 7201
Rev. 00 © 2000 Hans Pausch Röntgengerätebau Graf-Zeppelin-Str. 1 D-91056 Erlangen ALL RIGHTS RESERVED Ru
3. Adjustments
3.1 Installing the Tube Unit Support Arm 48
3.2 Central Beam to Center of Bucky 50
3.3 Central Beam to Center of I.I. 50
3.4 Tabletop, Longitudinal Movement Path Potentiometer 51
3.5 Tabletop, Transverse Movement Path Potentiometer 52
3.6 Bucky Movement Path Potentiometer 52
3.7 I.I. Carriage Movement Path Potentiometer 52
3.8 Table Tilt Movement Path Potentiometer 1 53
3.9 Table Tilt Movement Path Potentiometer 2 53
3.10 Table, Longitudinal Safety Switches 54
3.11 Tabletop, Transverse Safety Switches not configured 54
3.12 Tabletop, Longitudinal Safety Switches 55
3.13 I.I. Carriage Movement Path Safety Switches 55
3.14 Table Tilt Up Movement Path Switch Strike Plate 55
3.15 Table Tilt Down Movement Path Switch Strike Plate 55
3.16 +88° Tilt Movement Safety Switches 56
3.17 -20° Tilt Movement Safety Switches 56
3.18 Spindle Nut Safety Switches 56
3.19 Accessory Sensor Switches 57
3.20 Longitudinal Tabletop Belt Tension 57
3.21 Raise - Lower Table Belt Tension 57
3.22 Cassette Carriage Drive Belt Tension 58
3.23 Operation in the Service Mode 59
3.24 Startup 61
3.25 Collimator Basic Setting 62
3.26 Collimation to Cassette and I.I. Formats 63
3.27 Saving the Parameters in the PC 64
3.28 Setting Parameters - Electronics 65
4. Technical Maintenance
4.1 Mechanical and Electrical Checks 67
4.2 Function Test 70
4.3 Spare Parts - Overall View 72
4.4 List of Spare Parts 79
5. Troubleshooting 84
6. Replacing Boards 86
7. Version Updates
86
8. Maintenance Verification 87
9. Location of Identification Labels 88