Hitachi 8450H/R - Manual (Page 103)

Ch 4: System Environment Settings
Hitachi PC VisionBase 8450H/R Server 99
SCSI Utility Screen
Configuration of the SCSI Utility screen
When the SCSI Utility is started, the following screen is displayed:
NOTE: Because the SCSI controller installed on the master board has three bus systems, three displays are
provided for the SCSI controller on this screen.
Hitachi PC VisionBase 8450H/R Server does not use ports with Port Num 3400 of on-board Wide-SCSI
controllers. Therefore, setting for such port is unnecessary.
1. Adapter name
The following items are displayed concerning the SCSI controller (adapter) installed in the system equipment.
Choosing this will display a submenu, on which you can make settings for the SCSI controller and for the SCSI
device(s) connected.
-
Name: Adapter name
-
Port Num: Port number
-
IRQ
-
Current: Currently usable or not
-
Next-Boot: Usable or not when the system is started next time
-
NvRAM Found: NvRAM is provided or not
2. Menu items
Choose these menus as required. See “Other Functions” on page 106 for details of each item.
3. Cursor
You can move the cursor (shadowed portion) with arrow keys .
“SYM53C810” is displayed for the Narrow-SCSI controller. Use this to install a removable device other than an
internal DLT.
“SYM53C896” is displayed for the Wide-SCSI controller. Use this only when installing an internal DLT.
Two displays are provided for the Wide-SCSI controller, because it has two ports.
The screen above and the screens in succeeding descriptions are merely examples. Depending on the
configuration of the system equipment, the contents of the display might be slightly different.
Items displayed in white on the screen cannot be selected.
1
2
3