Hitachi 8450H/R - Manual (Page 32)

Ch 2: Installation and Use of Devices
28 Hitachi PC VisionBase 8450H/R Server
Turning Power On/Off
Turning Power On
1. Turn on the peripheral devices.
2. Open the front door of the system equipment.
3. Press the POWER switch on the front of the system equipment.
NOTE: Depending on the capacity of the memory DIMM installed in the system equipment, it might take several
minutes for the initial screen to be displayed.
If power cannot be turned on or after processing stops for 10 minutes or more at the time of booting the
OS, press the POWER switch to turn off, and then turn on the power.
The POWER switch stores power-on/off information. When a power outage occurs when you use a
UPS, you can start the system equipment immediately after power is restored.
Wait at least 5 seconds between power-on and power-off operations.
When operating on the power supply, follow the specified procedure to protect the system equipment
from a failure.
Some peripheral devices must be turned on after the system equipment. Refer to the manual
attached to each peripheral device for details.
POWER switch
POWER lamp