Hitachi 8450H/R User Manual
Page 74
Ch 3: Installing Optional Devices
70
Hitachi PC VisionBase 8450H/R Server
1.
Set a SCSI ID for the internal DAT.
Use the short bar to set the SCSI ID into the range of 0 to 6. Use a pair of tweezers for inserting and removing
the short bar. The following table shows the correspondence between the SCSI IDs and the settings on the short
bar. The short bar is factory-set at 3.
NOTE: You can use internal DATs without setting a terminating resistor, because a terminating resistor has
already been installed in the internal SCSI cable (for removable devices).
Store the removed short bars properly.
Be sure to set SCSI IDs so that there is no duplication within the group of SCSI devices connected
with the same internal SCSI cable.
SCSI ID
Setting on the short bar
0
1
2
3
4
5
6