Hitachi 8450H/R - Manual (Page 23)

Ch 2: Installation and Use of Devices
Hitachi PC VisionBase 8450H/R Server 19
50 Self Test Status — The autoloader is executing the power-on self-test.
51 SemiLoaded Status — Although a cartridge is in the drive, it has not been loaded
(“semi-loaded” status).
52 Stray Tape:
Insert Empty
Mag Information — The autoloader does not contain a magazine for taking a
cartridge from the drive. Insert a magazine with an empty
slot.
53 Tape Fault Error Blinking The drive contains a defective cartridge.
Use a new DDS-compliant tape.
54 Tape Full Error On A read, space, write, or write file mark command detected
an unexpected EOP (For a read operation, this message
sometimes indicates that data extends over the current and
the succeeding cartridges).
55 Tape has DC
Data Error On Although compressed data was detected when a read
command was executed, the drive settings do not
correspond with decompression of data (The drive is
factory-set to compressed mode. If it is unchanged, this
error cannot occur).
56 Tape Position
Lost Error Blinking A write, read, space, or rewind command terminated
abnormally. The current tape position is immediately after
the erroneous data area. Reset the data position, and retry.
57 Tape Stuck Error Blinking A cartridge is stacked in the drive. Attempt to forcibly eject
the cartridge. If the error still recurs, contact the store where
you bought the system or call the maintenance personnel.
58 Unloading Status — • The drive is unloading a cartridge.
• The drive is ejecting a cartridge and returning it to the
magazine.
59 UpgradeErr Error Blinking Upgrading firmware failed. Check the SCSI cable for
connection, and retry.
60 Worn Media Error Blinking A high error ratio was detected during a write operation.
This indicates that the service life of the cartridge is coming
to an end. Copy the data in the cartridge to a new one, and
discard the old one.
61 Write x.y Status — The drive is writing data to tape (“x.y”:1 is the accumulated
compression ratio since power-on or since the compression
ratio was cleared).
62 Write Protected
Tape Error Blinking When a write, write file mark, or erase command was
executed, processing could not be completed because the
cartridge was write-protected. Cancel the write protection,
and retry.
63 Write Fail Error Blinking A write, write file mark, or erase command failed. Use a new
cartridge.
No. Message Type Operator-
alert lamp
Meaning