HP 8100C - Manual (Page 64)

Troubleshooting the digital sender 63
This will clear the
configuration and all the
destinations. Do you really
want to proceed? You are being asked to
confirm that you want to reset
the digital sender to the
factory defaults. Contact the administrator.
This will clear your changes.
Do you really want to
proceed? You are being asked to
confirm that you want to
discard all changes made in
the configuration menu. Contact the administrator.
Too many e-mail recipients.
Last e-mail recipient deleted. You can send an e-mail
message to a maximum of
1,024 e-mail addresses
(including all those in
distribution lists). Press O K ( F1 ) to clear the message and
continue with the transmission. Send the
same message again to all the recipients
who were not included in the first
transmission.
Too many fax recipients. Last
fax recipient deleted. You can send a fax to a
maximum of 1,024
destinations. Press O K ( F1 ) to clear the message and
continue with the transmission. Send the
same fax again to all the recipients who were
not included in the first transmission.
Too many matches. If the
recipient was not found,
press CANCEL and refine
your query.
Partial results.
number items found. The number of entries that
matches the criteria in your
LDAP search is greater than
the maximum number of
results that the digital sender
has been configured to
return. ● Narrow the scope of your search, either
by entering a more specific search string
or using different search criteria.
● If the problem persists, contact the
administrator.
Unexpected pages in second
pass. Job canceled. You selected duplex mode
and there are more pages in
the second pass than in the
first. Press any key to clear the message. Check
your pages and retry the job.
You do not have sufficient
access rights. The account name used to
authenticate searches with
LDAP server has insufficient
rights to access the
information. Contact the administrator.
You need to become a
registered user to use this
digital sender. Please contact
the administrator. Only registered users are
allowed to use the digital
sender, and only the
administrator can make you a
registered user. Contact the administrator.
You need to register to use
this digital sender. Only registered users are
allowed to use the digital
sender. ● Register as a user from the Users menu
(under Setup), or the login prompt, if it
appears.
● If you cannot register yourself, contact the
administrator.
Your profile is not enabled.
Contact the administrator. The administrator needs to
validate new user profiles
and any changes made to
user profiles. Contact the administrator.
Control panel messages (continued)
Message Description Action