Henny Penny EVOLUTION ELITE EEG-141 - Manual (Page 19)

Model EEG-141, 142, 143, 144
2-9. ELECTRICAL
REQUIREMENTS
(Continued)
To avoid electrical shock, do not disconnect the ground
(earth) plug. This fryer must be adequately and safely
grounded (earthed). Refer to local electrical codes for
correct grounding (earthing) procedures or in absence of local
codes, with The National Electrical Code, ANSI/NFPA No.
70-(the current edition). In Canada, all electrical connections
are to be made in accordance with CSA C22.2, Canadian
Electrical Code Part 1, and/or local codes.
Disconnect power supply before a thorough cleaning or servicing
the fryer
609 2-7
2-10. MOTOR BEARINGS The electric motor bearings are permanently lubricated. DO NOT
LUBRICATE.
2-11. LIGHTING AND
SHUTDOWN OF THE
BURNERS
1. Turn the power switch to the OFF position.
2. Wait at least 5 minutes and then turn the power switch to the
ON position.
3. Press button on the controls (left or right).
4. The burner lights and operates in a Melt Cycle until the
shortening reaches a preset temperature.
6. Once the display shows a product selection or a double dashes,
press the desired product button.
The fryer is equipped with a ignition spark module which has a
set ignition safety time (TSA) of 90 seconds.
To shutdown burner:
1. Press button on the controls (left or right).
2. Turn the power switch to the OFF position.
NOTE: This turns off all vats.