Henny Penny EVOLUTION ELITE EEG-141 - Manual (Page 35)

Model EEG-141, 142, 143, 144
809 3-14
7. Scrape or brush the sides and the bottom of the vat. Be
careful not to damage the sensing probes.
Do not use steel wool, other abrasive cleaners or cleaners/
sanitizers containing chlorine, bromine, iodine or ammonia
chemicals, as these will deteriorate the stainless steel
material and shorten the life of the unit.
Do not use a water jet (pressure sprayer) to clean the unit,
or component damage could result.
8. Once the vat is clean and the display shows
“SCRUB VAT COMPLETE?” “YES NO”. Press
√√√√√ button for
YES and the display shows “WASH VAT” “YES NO”.
9. Press
√√√√√ button and display shows “WASHING”. The oil circu-
lates through the vat for several minutes. Once the wash cycle
is complete, display shows “WASH AGAIN?” “YES NO”.
10. Press
√√√√√ button for YES if another wash is needed, otherwise
press X button for NO and the display shows “CLOSE DRAIN”
Push-in on the drain knob to close the drain
(Figure 3) and the
display shows “RINSING” and vat fills with oil.
11. Once the vat is filled, “OPEN DRAIN” shows in display. Pull-
out on drain knob to open the drain (Figure 4) and display shows
“RINSING”. When rinsing is complete, display shows “RINSE
AGAIN?” “YES NO”.
12. Press
√√√√√ button for YES if another rinse is needed, otherwise
press X button for NO. The display shows “POLISH?” “YES”.
13. Press
√√√√√ button for YES and the oil is “polished” by circulating
it through the filtering system. The display shows “5:00 STOP
POLISH”. If desired, press X button to stop the polishing,
otherwise the oil is polished for 5 minutes.
14. Once the oil is polished, the display shows “FILL VAT?” “YES”.
Press
√√√√√ button and display shows “CLOSE DRAIN”.
Push-in
on the drain knob to close the drain (Figure 3), the display
shows “FILLING” and the vat then re-fills with oil.
15. Once full, the display shows “IS POT FILLED?” “YES NO”.
Press
√√√√√ button for YES and fryer returns to normal operation.
If X button is pressed, the display shows “FILLING”. You can
try to fill the vat 4 times and then the control shows “ADD
QUIT”. Press
√√√√√ button and JIB pump runs 60 seconds, filling
the vat from the JIB. Press X button and controls return to
normal operation.
3-12. DAILY FILTERING
(Continued)
Figure 3
Figure 4