Henny Penny EVOLUTION ELITE EEG-141 - Manual (Page 68)

Model EEG-141, 142, 143, 144
7-1. TROUBLE SHOOTING GUIDE
(Continued)
Oil foaming or boiling
over top of vat
Oil will not
drain from vat
Filter motor runs but
pumps oil slowly
Bubbles in oil during
entire filtering process
Filter motor will not run
Problem Cause Correction
• Water in oil
• Improper or bad oil
• Improper filtering
• Improper rinsing after
cleaning the vat
• Drain valve clogged
with crumbs
• Drain trough clogged
• Filter line connections loose
• Filter paper or pad
clogged
• Filter not reassembled
correctly
• Filter pan not completely
engaged
• Filter pan clogged
• Damaged O-ring on filter
line receiver on fryer
• the thermal reset button on
the rear of the pump motor
is tripped
To prevent burns caused by
splashing shortening, turn
the unit's POWER switch to
the OFF position before
resetting the filter pump
motor’s manual reset
protection device.
• Drain and clean oil
• Use recommended oil
• Refer to filtering procedures
• Clean and rinse vat and then
dry thoroughly
• Open valve, force cleaning brush
through drain
• Remove right side panel and remove
plug from end of trough and clean
trough
• Tighten all filter line connections
• Change filter paper or pad
• Refer to assembly instructions on inside
of door
• Make sure filter pan return line is
pushed completely into the receiver on
the fryer
• Clean pan and change paper or pad
• Change O-ring
• Remove the right side panel and
allow time for the motor to cool
and then, using a screwdriver,
press hard against the button
until it clicks
7-2 609