Henny Penny EVOLUTION ELITE EEG-141 - Manual (Page 65)

Model EEG-141, 142, 143, 144
Program Code Change (SP-25) (Continued)
If satisfied with code, press and “*CODE CHANGED*”
shows in display.
If not satisfied with code, press and “*CANCEL” shows
in display, then reverts back to “SP-25” and “CHANGE, MGR
CODE? 1=YES”. Now the above steps can be repeated.
Usage Code Change (SP-26)
This allows the operator to change the reset usage code (factory set
at 1, 2, 3) to reset the usage amounts of each product. See Review
Usage step in Information Mode.
Press button and “SP-26 CHANGE USAGE CODE?
1=YES” flashes in the display. Press
and “ENTER
NEW CODE, P=DONE, I=QUIT show scrolls through the
display. Press the product buttons for new code.
If satisfied with code, press and “REPEAT NEW CODE,
P=DONE, I=QUIT, shows in display. Press same code
buttons.
If satisfied with code, press “*CODE CHANGED*”
shows in display.
If not satisfied with code, press and “*CANCEL” shows
in display, then reverts back to “SP-26” and “CHANGE,
USAGE CODE? 1=YES”. Now the above steps can be
repeated.
Dispose Requires Code ? (SP-27)
Press button and “SP-27 DISPOSE REQUIRES
CODE ?” flashes in the left display. Press the or
buttons to choose YES or NO. If set to YES, code 1, 2, 3
must be entered to discard the oil from the vat, using the
Dispose Mode.
Longer Fill Time (SP-28)
Press button and “SP-28 LONGER FILLTIME
ENABLED?” flashes in the left display. Press the or
buttons to choose YES or NO.
Let User Exit Fill (SP-29)
Press button and “SP-29 LET USER EXIT FILL”
flashes in the left display. Press the or
buttons to
choose YES or NO. If YES is chosen, the user can exit the
Express Filter
TM fill operation.
6-1. SPECIAL PROGRAM
MODE (Continued)
1009 6-9