HP 310X - Manual (Page 119)

Host Name The host name configured on the print server. It may be truncated.
Not Specified no host name was specified in a BOOTP response
or TFTP configuration file.
●
NPIxxxxxx the default name is NPIxxxxxx , where xxxxxx
represents the last six digits of the LAN hardware (MAC) address.
●
IP Address The Internet Protocol (IP) address assigned to the print server. This is a
required entry for its operation on a TCP/IP network. During initialization, a
temporary value
0.0.0.0 is displayed. After two minutes, a default IP
address 192.0.0.192 is assigned, which may not be a valid IP address
for your network.
Not Specified an IP address is not assigned or the value is zero. ●
Subnet
Mask The IP subnet mask configured on the print server. During initialization, a
temporary value
0.0.0.0 is displayed. Depending on configuration
parameters, the print server may automatically assign a usable default value.
Not Specified a subnet mask is not configured. ●
Default
Gateway The IP address of the gateway used when sending packets off the local
network. Only one default gateway may be configured. During initialization, a
temporary value
0.0.0.0 is displayed. If not provided, the IP address of
the print server is used.
Not Specified a default gateway is not configured. ●
Config By Identifies how the print server obtained its IP configuration.
Not Configured the print server was not configured with IP
parameters. Verify that TCP/IP is enabled, or check for error status.
●
BOOTP automatic configuration via a BOOTP server. ●
BOOTP/TFTP automatic configuration via a BOOTP server and
TFTP configuration file.
●
DHCP automatic configuration via a DHCP server. ●
DHCP/TFTP automatic configuration via a DHCP server and TFTP
configuration file.
●
RARP automatic configuration via the Reverse Address Resolution
Protocol.
●
User Specified manual configuration via Telnet, the printer’s
control panel, HP Web Jetadmin, embedded web server, or other
method.
●
Default IP the default IP address was assigned. This address
may not be a valid address for your network.
●
BOOTP
Server
or
DHCP
Server
or
RARP
Server
Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It
specifies the IP address of the system that responds to the print server’s
request for automatic TCP/IP configuration over the network.
Not Specified the configuration server’s IP address could not be
determined or was set to zero in the response packet.
●