HP 310X - Manual (Page 62)

cold-reset
Sets TCP/IP factory defaults. After a cold reset, power cycle the print server. Parameters for
other subsystems, such as IPX/SPX or AppleTalk, are not affected.
ews-config
Enables or disables the print server’s embedded web server to view or change configuration
values:
0 Disables.
1 (default) Enables.
tcp-mss
Specifies the maximum segment size (MSS) that the print server will advertise for use when
communicating with local subnets (Ethernet MSS=1460 bytes or more) or remote subnets
(MSS=536 bytes):
0 (default) All networks are assumed to be local (Ethernet MSS=1460 bytes or more).
1 Use MSS=1460 bytes (or more) for subnets, and MSS=536 bytes for remote networks.
2 All networks are assumed to be remote (MSS=536 bytes), except the local subnet.
MSS affects performance by helping to prevent IP fragmentation that may result in data
retransmission.
tcp-msl
Specifies the maximum segment life (MSL) in seconds. The range is 5 – 120 seconds. The
default is 15 seconds.
TCP/IP diagnostics parameters for Telnet
Telnet Parameter Description and Values
Last Config IP
(read-only parameter) The IP address of the system from which the print server's IP address
was configured.
TCP Conns
Refused (read-only parameter) The number of client TCP connections that are refused by the print
server.
TCP Access
Denied (read-only parameter) The number of times that client systems were denied access to the print
server because there was no allowable entry in the print server's host access list.
DHCP Lease Time (read-only parameter) The DHCP IP Address lease duration time in seconds.
DHCP Renew Time
(read-only parameter) The DHCP T1 timeout, specifying the DHCP lease renewal time in
seconds.
DHCP Rebind Time
(read-only parameter) The DHCP T2 timeout, specifying the DHCP lease rebind time in
seconds.
SNMP parameters for Telnet