HP 310X - Manual (Page 130)

46
INVALID SERVER
ADDRESS The TFTP server IP address specified for the print server (through
BOOTP) is an invalid IP address for specifying a single node. Check
your Bootptab file for proper entries.
47
INVALID TRAP
DEST ADDRESS One of the SNMP trap (Trap PDU) destination IP addresses specified
for the print server (through TFTP) is an invalid IP address for
specifying a single node. Check your TFTP configuration file.
48
CF ERR- FILE
INCOMPLETE The TFTP configuration file contained an incomplete last line that did
not end in a new line character.
49
CF ERR- LINE
TOO LONG A line being processed in the TFTP configuration file was longer than
the print server could accept.
4A
CF ERR-
UNKNOWN
KEYWORD A TFTP configuration file line contained an unknown keyword.
4B
CF ERR-
MISSING
PARAMETER A line in the TFTP configuration file was missing a required parameter.
4C
CF ERR-
INVALID
PARAMETER A line in the TFTP configuration file contained an invalid value for one
of the parameters on that line.
4D
CF ERR- ACCESS
LIST EXCEEDED The TFTP configuration file specified too many access list entries using
the “
allow: ” keyword.
4E
CF ERR - TRAP
LIST EXCEEDED The TFTP configuration file specified too many trap destination list
entries using the “
trap-destination: ” keyword.
4F
TFTP REMOTE
ERROR The TFTP transfer of the configuration file from the host to the print
server failed with the remote host sending a TFTP ERROR packet to the
print server.
50
TFTP LOCAL
ERROR The TFTP transfer of the configuration file from the host to the print
server failed with the local print server encountering some form of
inactivity timeout or excessive retransmissions situation.
51
TFTP RETRIES
EXCEEDED The overall retrying of the TFTP transfer of the configuration file from
the host to the print server has exceeded a retry limit.
52
BAD BOOTP/DHCP
REPLY An error was detected in the BOOTP or DHCP reply that the print
server received. The reply either had insufficient data in the UDP
datagram to contain the minimum BOOTP/DHCP header of 236 bytes,
had an operation field that was not BOOTPREPLY(0X02), had a header
field that did not match the print servers hardware address, or had a
UDP source port that was not the BOOTP/DHCP server port (67/udp).