HP 310X - Manual (Page 75)

Syslog
Priority
Controls the filtering of syslog messages that are sent to the syslog
server. The filter range is 0 to 8, with 0 being the most specific and
8 being the most general. Only messages that are lower than the
filter level specified (that is, higher in priority) are reported. The
default value is 8 which reports all syslog messages. A value of
zero effectively disables syslog reporting.
Idle Timeout
Specifies the number of seconds that an idle print connection is
allowed to remain open. Up to 3600 seconds can be set. 270 is the
default value. If set to 0, the timeout is disabled and TCP/IP
connections will remain open until closed by the device at the other
end of the network (for example, a workstation).
TTL/SLP
Specifies the IP multicast Time To Live (TTL) discovery setting
for Service Location Protocol (SLP) packets (used by the HP
Jetdirect Install Network Printer Wizard). The default value is 4
hops (the number of routers from the local network). The range is
1-15. If set to -1, multicast capability is disabled.
System
Contact
Identifies a person who is assigned to administer or service this
device. This field may include a phone number or similar
information. When configured, this parameter will be displayed on
the HP Jetdirect Home page.
System
Location
Specifies the physical location of the device or related information.
Only printable ASCII characters are allowed, up to 64 characters.
When configured, this parameter will be displayed on the
HP Jetdirect Home page.
Banner Page
Specifies whether to enable or disable printing of an LPD banner
page for print jobs.
IPX/SPX settings
Click on the
Networking
tab at the top of the web page. (Make sure that beneath
Configuration
in the left column of the page,
Network Settings
is selected.) Select
the
IPX/SPX
tab in the second row of tabs across the page. To assign a parameter
setting, enter the desired value and click [Apply] .
IPX/SPX Settings
IPX/SPX
Enable
Enables or disables the IPX/SPX protocols on the print server. If
the checkbox is empty, IPX/SPX is disabled.