Setting the fax error correction, To change the error correction setting, Selecting tone- or pulse-dialing mode – Hitachi 3300MFP User Manual
Page 101: To select tone- or pulse-dialing, Changing redial settings
EN
Setting the fax error correction 99
Note
The default set at the factory for stamp received faxes is
Off
.
Setting the fax error correction
Normally, the product monitors the signals on the telephone line while it is sending or receiving a
fax. If the product detects an error signal during the transmission and the error correction setting is
on, the product can request that a portion of the fax be resent.
You should only turn error correction off if you are having trouble sending or receiving a fax, and
you want to accept the errors in the transmission. Turning the setting off might be useful when you
are trying to send or receive a fax overseas, or if you are using a satellite telephone connection.
To change the error correction setting
1
Press menu/enter.
2
Use the < and > buttons to select
Fax Setup
and press menu/enter.
3
Use the < and > buttons to select
All Faxes
and press menu/enter.
4
Use the < and > buttons to select
Error Correction
and press menu/enter.
5
Use the < and > buttons to select
On
or
Off
and press menu/enter to save your selection.
Note
The default set at the factory for error correction is
On
.
Selecting tone- or pulse-dialing mode
Use this procedure to set the product to tone- or pulse-dialing mode. The default is set to tone.
Leave this as tone unless you know your phone line is incapable of tone dialing.
To select tone- or pulse-dialing
1
Press menu/enter.
2
Use the < or > button to select
Fax Setup
and press menu/enter.
3
Press > once to select
Fax Send Setup
and press menu/enter.
4
Use the < or > button to select
Dialing Mode
and press menu/enter.
5
Use the < or > button to select
Tone
or
Pulse
and press menu/enter to save your selection.
Changing redial settings
If the product was unable to send a fax because the receiving fax machine did not answer or was
busy, the product will attempt to redial based on the redial on busy and redial on no answer
options. Use the procedures in this section to turn these options on or off.
Note
The product will, by default, redial if the receiving fax machine is busy but will not, by default, redial
if the receiving fax machine does not answer.