Is there a message on your computer screen, Is media being pulled into the printer correctly, Are there media jams – Hitachi 3300MFP User Manual
Page 157: Is the print quality poor, Are the printer settings appropriate for the media, Onscreen error messages, Printer not responding/error writing to lpt1, Cannot access port (in use by another application), Pages did not print, Pages printed, but there was a problem
EN
Pages did not print 155
Pages did not print
Is there a message on your computer screen?
See
for more information.
Is media being pulled into the printer correctly?
See
for more information.
Are there media jams?
See
for more information.
Pages printed, but there was a problem
Is the print quality poor?
See
for more information.
Is the printed page different than what appeared onscreen?
See
Printed page is different from what appeared onscreen
for more information.
Are the printer settings appropriate for the media?
See
for more information.
Onscreen error messages
Printer not responding/error writing to LPT1
Check the following:
●
Is the product in its Ready state?
●
Are the power cord and parallel or USB cable correctly connected?
Try the following:
●
Disconnect the power cord and parallel or USB cable at both ends and reconnect them.
●
Use another IEEE 1284-B-compliant parallel or USB cable.
Cannot access port (in use by another application)
There is a device conflict. This might occur if another device is installed on your computer and
running status software. The status software dominates the parallel port on the computer and will
not allow the HP LaserJet 3300 to access the port.
Try the following:
●
Disable all of the status windows for other printers.
●
Make sure that the printer’s port setting is correct. Access the port settings on the Printer
Properties Details tab.