No copy came out, Is media loaded in the input tray, Is the original loaded correctly – Hitachi 3300MFP User Manual
Page 170: Is the wrong device selected, Copies are blank, or images are missing or faded, Is the print cartridge low on toner, Is the original of poor quality, Does the original have a colored background, Improving copy quality, Preventing problems
168 13 Troubleshooting copy problems
EN
No copy came out
Is media loaded in the input tray?
Load media in the printer. See
Installing and loading the media input trays
for more information.
Is the original loaded correctly?
Make sure that the original is loaded correctly:
●
ADF input tray: The original should be loaded top down in the ADF input tray, with the side to
be copied facing up. See
Loading originals to copy or scan
for more information.
●
Flatbed scanner: Place original document face down on the flatbed scanner with the top left
corner of the document located in the lower right corner of the glass.
Is the wrong device selected?
In HP LaserJet Copy Plus, make sure that the printer you are intending to use is selected in the
Printer field as the current device when you press start/copy.
Copies are blank, or images are missing or faded
Is the sealing tape still in the printer print cartridge?
The sealing tape might still be in the print cartridge. Remove the print cartridge, pull out the
sealing tape, and reinstall the print cartridge. See
for more information.
Is the print cartridge low on toner?
Copies are made using the printer. If the print cartridge is low on toner, the copies will be faded.
Is the original of poor quality?
The accuracy of the copy depends on the quality and size of the original. Try adjusting the contrast
with HP LaserJet Copier. See
Using HP LaserJet Copier software
for instructions. If your original
is too light, the copy might not be able to compensate, even if you adjust the contrast.
Does the original have a colored background?
Colored backgrounds might cause images in the foreground to blend too much or the background
to appear in a different shade. Try using HP LaserJet Copier to adjust the settings before copying
or to enhance the image after it has been copied. See
Using HP LaserJet Copier software
for
instructions.
Improving copy quality
This section provides information on the following topics:
●
Preventing problems
●
Identifying and correcting copy/scan defects
Preventing problems
The following are a few simple steps you can take to improve copy quality: