Installing the adf input tray, Connecting the power cord – Hitachi 3300MFP User Manual
Page 32
30 2 Getting started
EN
Installing the ADF input tray
If your HP LaserJet 3300 series product comes with an ADF, or if you purchased the HP LaserJet
3300 series ADF accessory, use the following instructions to install the ADF input tray:
1
Align the two tabs on the input tray with the two grooves in the ADF lid.
2
Slide the tray into the grooves as shown until the tray snaps into place.
Connecting the power cord
To connect your product to a power source, use the following steps.
1
If you have the 220V product, locate the power switch on the back of the product and make
sure the product is switched off.
2
Connect the power cord to the product, as shown (1).
3
Plug the other end of the power cord directly into a grounded AC outlet (2).
4
If you have the 220V product, switch on the power. If you have the 110V product, there is no
power switch. It will automatically power on when it is plugged in.
Note
HP does not recommend the use of uninterrupted power supply (UPS) battery backup devices or
surge suppressors with this product. Many surge suppressors and battery backups can cause print
defects.
1
2