Hitachi 3300MFP - Manual (Page 233)

EN HP LaserJet 3330 fax 231
FCC Part 68 Requirements (US)
This equipment complies with FCC rules, Part 68. On the back of this equipment is a label that
contains, among other information, the FCC registration number and ringer equivalence number
(REN) for this equipment. If requested, this information must be provided to the telephone
company. The REN is used to determine the quantity of devices which may be connected to the
telephone line. Excessive RENs on the telephone line may result in the devices not ringing in
response to an incoming call. In most, but not all, areas, the sum of the RENs should not exceed
five (5.0). To be certain of the number of devices that may be connected to the line, as determined
by the total RENs, contact the telephone company to determine the maximum REN for the calling
area.
This equipment uses the following USOC jacks: RJ11C.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This
equipment is designed to be connected to the telephone network or premises wiring using a
compatible modular jack which is Part 68 compliant. This equipment cannot be used on telephone
company-provided coin service. Connection to Party Line Service is subject to state tariffs. If this
equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. If advance notice isn't
practical, the telephone company will notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone
company may make changes in its facilities, equipment, operations, or procedures that could
affect the operation of the equipment. If this happens, the telephone company will provide advance
notice in order for you to make the necessary modifications in order to maintain uninterrupted
service. If trouble is experienced with this equipment, please see the numbers in the front of this
manual for repair and (or) warranty information. If the trouble is causing harm to the telephone
network, the telephone company may request you remove the equipment from the network until
the problem is resolved. The following repairs can be done by the customer: Replace any original
equipment that came with the product. This includes the print cartridge, the supports for trays and
bins, the power cord, and the telephone cord. It is recommended that the customer install an AC
surge arrestor in the AC outlet to which this device is connected. This is to avoid damage to the
equipment caused by local lightning strikes and other electrical surges.
Telephone consumer protection act (US)
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a
computer or other electronic device, including fax machines, to send any message unless such
message clearly contains, in a margin at the top or bottom of each transmitted page or on the first
page of the transmission, the date and time it is sent and an identification of the business, other
entity, or individual sending the message and the telephone number of the sending machine or
such business, other entity, or individual. (The telephone number provided cannot be a 900
number or any other number for which charges exceed local or long-distance transmission
charges.) In order to program this information into your facsimile, please see
Setting the
information in the fax header .
Fax resolution (standard) 203 by 98 dots per inch (dpi)
Fax resolution (fine) 203 by 196 dpi
Fax resolution (superfine) 300 by 300 dpi (no halftone)
Fax resolution (photo) 300 by 300 dpi (halftone enabled)