High End Systems SHOWGUN - Manual (Page 21)

CHAPTER 2
Setup and Configuration
SHOWGUN ® User Manual 9
Mounting the Fixture
You can mount your SHOWGUN ® fixture suspended from a support system (such as a truss) or
freestanding on its base.
WARNING!
Equipment suitable for dry locations only. Do not expose this
equipment to rain or moisture.
CAUTION!
SHOWGUN fixtures must be installed and operated by trained personnel
only.
Always use a secondary safety cable when mounting this fixture.
Do not mount on a flammable surface or within 1 m (3 ft) of a
flammable object.
Maintain a minimum focus distance of 4 m (13.1 ft) from any flammable
object.
3
Maintain a minimum focus distance to non-flammable lighted object of
3 m (9.8 ft)
Note: Due to the wide variety of possible lighting designs, High End
Systems cannot make specific mounting recommendations. Consider
the following procedure as a suggested guideline only.
Mounting the Fixture Upright
CAUTION!
Do not mount the fixture upright without the four rubber feet
attached.
To mount the fixture upright:
1. Place the fixture on a sturdy, stable non-flammable surface that will support more than the
63.5 kg (140 lb) weight of the SHOWGUN ® fixture. If the surface is above floor height, use
safety cables to secure the fixture to the surface.
2. Disengage Pan and Tilt locks before powering up the fixture.