Document Outline

• General Safety Information
  • Safety Alert Symbol
  • Signal Words
  • Special Symbols
  • Equipment Warning Labels
  • Qualified Personnel
  • Equipment Inspection
  • Handling and Storage
  • Disposal
• Installation Precautions
  • Location and Ambient Requirements
  • Mounting Requirements
  • Conductor Routing and Grounding
    • The Metal Of Conduit Is Not An Acceptable Ground.
  • Power Connections
  • Protection
• System Integration Precautions
  • Personnel Protection
  • System Setup Requirements
• Operational and Maintenance Precautions
• Motor Characteristics
  • Motor Autotuning
  • Pulse Width Modulation Operation
  • Low Speed Operation
  • Overload Protection Adjustment
  • Operation Above 60 Hz
  • Power Factor Correction
  • Light Load Conditions
  • Motor/Load Combinations
  • Load-produced Negative Torque
  • Motor Braking
• H9 ASD Characteristics
  • Over-current Protection
  • ASD Capacity
  • Using Vector Control
• Installation and Connections
  • Installation Notes
  • Mounting the H9 ASD
  • Connecting the H9 ASD
    • Power Connections
    • System Grounding
    • Lead Length Specifications
  • I/O and Control
    • Terminal Descriptions
    • I/O Circuit Configurations
    • Typical Connection Diagram
    • Startup and Test
• Electronic Operator Interface
  • EOI Operation
  • EOI Remote Mounting
  • EOI Features
    • LED Display
      • LED Character/Font Information
    • LCD Display
      • Primary Menus of the LCD Display
      • LED/LCD Display Installation Note
  • Keypad Remote Mounting
    • Remote Keypad Required Hardware
    • Keypad Installation Precautions
    • Keypad Remote Mounting w/o the ASD-MTG-KIT
      • Keypad Dimensions (mounting)
    • Keypad Remote Mounting using the ASD-MTG-KIT
      • Keypad ASD-MTG-KIT Dimensions (mounting)
• Command Mode and Frequency Mode Control
  • Command Control (F003)
  • Frequency Control (F004)
    • Command and Frequency Control Selections
  • Override Operation
    • Command and Frequency-Control Override Hierarchy
    • Command Control Selections
    • Frequency Control Selections
• System Configuration and Menu Options
  • Root Menus
    • Frequency Command Mode
    • Monitor Mode
      • Main Monitor Selections
    • Program Mode Menu Navigation
• System Operation
  • Initial Setup
  • Startup Wizard Parameters
    • Startup Wizard Parameter Requirements
      • Voltage and Frequency Rating of the Motor
      • Upper Limit Frequency
      • Lower Limit Frequency
      • Automatic Acceleration/Deceleration
      • Acceleration Time
      • Deceleration Time
      • Volts per Hertz Setting
      • Motor Current Rating
      • Motor RPM
      • Command Source
      • Frequency Reference Source
      • Display Unit
      • Wizard: Finish
  • Operation (Local)
  • Default Setting Changes
  • Save User Settings
• Direct Access Parameter Information
  • Direct Access Parameters/Numbers
• Alarms, Trips, and Troubleshooting
  • Alarms and Trips
  • User Notification Codes
  • Alarms
  • Trips/Faults
    • Viewing Trip Information
      • Trip History
      • Trip Record at Monitor Screen
    • Clearing a Trip
• Enclosure Dimensions and Conduit Plate Information
  • Enclosure Dimensions
• Current/Voltage Specifications
• Cable/Terminal/Torque Specifications
• Short Circuit Protection Recommendations
• Dynamic Braking Resistor Wire/Cable Specifications
• H9 ASD Optional Devices