Toshiba H9 - Manual (Page 273)

H9 ASD Installation and Operation Manual 265
Cable/Terminal/Torque Specifications
Installation should conform to the 2005 National Electrical Code Article 110 (NEC ) (Requirements for Electrical
Installations), all regulations of the Occupational Safety and Health Administration, and any other
applicable national, regional, or industry codes and standards.
Note: The following ratings are guidelines and shall not be the sole determining factor of the
lug or wire size used with the H9 ASD. Application-specific applicables, wire insulation
type, conductor material, and local and regional regulations are but a few of the
considerations when selecting the actual lug and wire type to be used with the H9 ASD.
Note: Cable/Terminal specifications are based on the rated current of the H9 ASD and Do
Not include the 10% Service Factor.
Note: Use only 75° C copper wire/cable for motor and power connections.
For further installation information see the section titled Installation and Connections on pg. 14 .
Note: (*) Indicates that the item is one of a set of two parallel cables.
Table 20. 230-Volt H9 ASD Cable/Terminal/Torque Specifications.
Model
Number
VT130H9U
MCP Rating
(Amps)
Wire/Cable Size Lug Size Range
Terminal
Board
Torque
AWG or kcmil
Input/Output Power
Wire-Size/Lug-Capacity for
Input/Output Power
TB1 – 4
Terminals
3Ø-Input 3Ø-Output
Recommended Maximum 3Ø-Input 3Ø-Output In-Lbs./Nm
2035 30 14 10
14 to 8
20
(3-core shield)
5.3/0.6
11.5/1.3
2055 30 10 10
2080 50 8 8
12 to 8 17.7/2.0
2110 50 8 8
2160 75 6 3
8 to 3 21/2.4 2220 100 4 3
2270 125 3 3
2330 150 2 2 12 to 1/0 4 to 1/0 50/5.7 53/6
2400 175 1/0 4/0
6 to 250 2 to 300 275/31 168/19
2500 200 2/0 4/0
2600 250 3/0 4/0
2750 300 4/0 4/0
210K 400 *3/0 *1/0
6 to 250 275/31
212K 500 *250 *250