F920, F921, F922 – Toshiba H9 User Manual
Page 228: F923, F924, F925
220
H9 ASD Installation and Operation Manual
My Function Percent Data 3
Program
⇒
My Function
⇒
My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Percent Data 3.
The analog signal is selected using the Input Setting number from
Direct Access Number — F920
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Percent Data 4
Program
⇒
My Function
⇒
My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Percent Data 4.
The analog signal is selected using the Input Setting number from
Direct Access Number — F921
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Percent Data 5
Program
⇒
My Function
⇒
My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Percent Data 5.
The analog signal is selected using the Input Setting number from
Direct Access Number — F922
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 1
Program
⇒
My Function
⇒
My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Frequency Data 1.
The analog signal is selected using the Input Setting number from
Direct Access Number — F923
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 2
Program
⇒
My Function
⇒
My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Frequency Data 2.
The analog signal is selected using the Input Setting number from
Direct Access Number — F924
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 3
Program
⇒
My Function
⇒
My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Frequency Data 1.
The analog signal is selected using the Input Setting number from
Direct Access Number — F925
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %