Toshiba H9 - Manual (Page 99)

H9 ASD Installation and Operation Manual 91
Input Terminal 12 (LI4) Function
Program
⇒
Terminal
⇒
Input Terminals
This parameter is used to set the functionality of the LI4 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI4 terminal to any one
of the user-selectable functions listed in
Table 5 on pg. 236 .
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N 58685) for
more information on the function of this terminal.
Direct Access Number — F122
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 13 (LI5) Function
Program
⇒
Terminal
⇒
Input Terminals
This parameter is used to set the functionality of the LI5 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI5 terminal to any one
of the user-selectable functions listed in
Table 5 on pg. 236 .
Note: The Expansion IO Card Option 2 option board (P/N ETB004Z)
is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N 58686) for
more information on the function of this terminal.
Direct Access Number — F123
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 14 (LI6) Function
Program
⇒
Terminal
⇒
Input Terminals
This parameter is used to set the functionality of the LI6 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI6 terminal to any one
of the user-selectable functions listed in
Table 5 on pg. 236
Note: The Expansion IO Card Option 2 option board (P/N ETB004Z)
is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N 58686) for
more information on the function of this terminal.
Direct Access Number — F124
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F122 F124