Table 5 on pg. 236, Table 5 on, Pg. 236 – Toshiba H9 User Manual
Page 244: Terminal selection descriptions
236
H9 ASD Installation and Operation Manual
Table 5. Discrete Input Terminal assignment selections and descriptions.
Sel. No.
Terminal Selection Descriptions
NO NC
0
1
Unassigned
— No operation.
2
3
Forward
— Provides a Forward run command.
4
5
Reverse
— Provides a Reverse run command.
6
7
Standby
— Enables the Forward and Reverse operation commands.
8
9
Reset
— Resets the device and any active faults.
10
11
Preset Speed 1
— Preset Speed 1 is used as the LSB of the 4-bit nibble that is used to select a Preset Speed.
12
13
Preset Speed 2
— Preset Speed 2 is used as the second bit of the 4-bit nibble that is used to select a Preset Speed.
14
15
Preset Speed 3
— Preset Speed 3 is used as the third bit of the 4-bit nibble that is used to select a Preset Speed.
16
17
Preset Speed 4
— Preset Speed 4 is used as the MSB of the 4-bit nibble that is used to select a Preset Speed.
18
19
Jog
— This terminal activates a Jog for the duration of the activation. The Jog settings may be configured at
.
20
21
Emergency Off
— Terminates the output signal from the drive and may apply a brake if so configured. The braking
method may be selected at
.
22
23
DC Braking
— Upon activation the drive outputs a DC current that is injected into the windings of the motor to
quickly brake the motor.
24
25
A/D 1
— Accel/Decel Switching 1 — Used in conjunction with Accel/Decel Switching 2. Activate or deactivate this
terminal to toggle to and from the Accel/Decel profile 1 through 4.
Accel/Decel profiles are comprised of the Accel/Decel settings, Pattern, and Switching Frequency, respectively.
See
for more information on this terminal setting.
26
27
A/D 2
— Accel/Decel Switching 2 — Used in conjunction with Accel/Decel Switching 1. Activate or deactivate this
terminal to toggle to and from the Accel/Decel profile 1 through 4.
Accel/Decel profiles are comprised of the Accel/Decel settings, Pattern, and Switching Frequency, respectively.
See
for more information on this terminal setting.
28
29
V/f Switching 1/V/f Switching 2
— Activating combinations of discrete input terminals V/f Switching 1 and 2
allow for the selection of a V/f switching profile as listed below.
30
31
Note:
NO/NC = Normally Open/Normally Closed.
V/f Switching Terminal
V/f Selection
#1
#2
0
0
1
0
1
2
1
0
3
1
1
4
1 = Terminal Activated
The 1–4 settings of the V/f Switching
selections are performed at parameters
–