F210, F211 – Toshiba H9 User Manual

Page 118

Advertising
background image

110

H9 ASD Installation and Operation Manual

RR Input Point 1 Setting

Program

Frequency

Speed Reference Setpoints

This parameter is used to set the gain and bias of the RR input terminal when
the RR terminal is used as the control input while operating in the Speed
Control
mode or the Torque Control mode.

This parameter sets the RR input level that is associated with the RR Input
Point 1 Frequency
setting when operating in the Speed control mode or is
associated with the RR Input Point 1 Rate setting when operating in the
Torque Control mode.

Speed Control

Perform the following setup to allow the system to perform Speed control from
the RR input terminal:

• Set RR Input Point 1 Frequency (

F211

).

• Set RR Input Point 1 Setting (

F210

) — the input analog signal level that

corresponds to the frequency setting at RR Input Point 1 Frequency.

• Set RR Input Point 2 Frequency (

F213

).

• Set RR Input Point 2 Setting (

F212

) — the input analog signal level that

corresponds to the frequency setting at RR Input Point 2 Frequency.

RR Input Speed Control Setup

Perform the following setup to allow the system to receive Speed control input
at the RR input terminal:

• Program

⇒ Fundamental ⇒ Standard Mode Selection ⇒ Frequency Mode

1

RR.

• Program

⇒ Fundamental ⇒ Standard Mode Selection ⇒ Command Mode

Selection

Terminal Block.

• Provide a Run command (F and/or R).

Once set, as the RR input voltage changes, the output frequency of the ASD
will vary in accordance with the above settings.

This parameter value is entered as 0% to 100% of the RR input signal range.

Direct Access Number — F210

Parameter Type — Numerical

Factory Default — 0

Changeable During Run — Yes

Minimum — 0

Maximum — 100

Units — %

Frequency Settings

RR Input Point 1 Frequency

Program

Frequency

Speed Reference Setpoints

This parameter is used to set the gain and bias of the RR input terminal when
the RR terminal is used as the control input while operating in the Speed
Control
mode.

This parameter sets RR Input Point 1 Frequency and is the frequency that is
associated with the setting of RR Input Point 1 Setting when operating in the
Speed Control mode.

See RR Input Point 1 Setting for more information on this setting.

Direct Access Number — F211

Parameter Type — Numerical

Factory Default — 0.00

Changeable During Run — Yes

Minimum — 0.00

Maximum — Max. Freq. (

F011

)

Units — Hz

RR

F210

F211

Advertising