Toshiba H9 - Manual (Page 105)

H9 ASD Installation and Operation Manual 97
Input Terminal 19 (B14) Function
Program
⇒
Terminal
⇒
Input Terminals
This parameter is used to set the functionality of the B14 discrete input
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable B14 terminal to any one
of the user-selectable functions listed in
Table 5 on pg. 236 .
See the My Function Instruction Manual (P/N 58692) for more information
on the function of this terminal.
Direct Access Number — F166
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 20 (B15) Function
Program
⇒
Terminal
⇒
Input Terminals
This parameter is used to set the functionality of the B15 discrete input
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable B15 terminal to any one
of the user-selectable functions listed in
Table 5 on pg. 236 .
See the My Function Instruction Manual (P/N 58692) for more information
on the function of this terminal.
Direct Access Number — F167
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Output Terminal 10 (R3) Function
Program
⇒
Terminal
⇒
Output Terminals
This parameter sets the functionality of the R3 output terminal to any one of the
user-selectable functions listed in
Table 8 on pg. 241 .
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
See the instruction manual for the 16-bit BIN/BCD option for more
information on the function of this terminal.
Direct Access Number — F168
Parameter Type — Selection List
Factory Default — OFF
Changeable During Run — No
Output Terminal 11 (R4) Function
Program
⇒
Terminal
⇒
Output Terminals
This parameter sets the functionality of the R4 output terminal to any one of the
user-selectable functions listed in
Table 8 on pg. 241 .
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
See the instruction manual for the 16-bit BIN/BCD option for more
information on the function of this terminal.
Direct Access Number — F169
Parameter Type — Selection List
Factory Default — OFF
Changeable During Run — No
F166 F169