Toshiba H9 - Manual (Page 102)

94 H9 ASD Installation and Operation Manual
Output Terminal 6 (R1) Function
Program
⇒
Terminal
⇒
Output Terminals
This parameter is used to set the functionality of the R1 discrete output
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable R1 terminal to any one of
the user-selectable functions listed in
Table 8 on pg. 241 .
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N 58685) for
more information on the function of this terminal.
Direct Access Number — F135
Parameter Type — Selection List
Factory Default — Always OFF
Changeable During Run — No
Output Terminal 7 (OUT5) Function
Program
⇒
Terminal
⇒
Output Terminals
This parameter is used to set the functionality of the OUT5 discrete output
terminal.
In addition, this output terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT5 terminal to any
one of the user-selectable functions listed in
Table 8 on pg. 241 .
Note: The Expansion IO Card Option 2 option board (P/N ETB004Z)
is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N 58686) for
more information on the function of this terminal.
Direct Access Number — F136
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
Output Terminal 8 (OUT6) Function
Program
⇒
Terminal
⇒
Output Terminals
This parameter is used to set the functionality of the OUT6 discrete output
terminal.
In addition, this output terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT6 terminal to any
one of the user-selectable functions listed in
Table 8 on pg. 241 .
Note: The Expansion IO Card Option 2 option board (P/N ETB004Z)
is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N 58686) for
more information on the function of this terminal.
Direct Access Number — F137
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
F135 F137