FANUC Robotics America GFK-1535A - Manual (Page 9)

GFK-1535A Chapter 1 Introduction 1-5
1
The Genius NIU
The VersaMax Genius Network Interface Unit (IC200GBI001) interfaces a
VersaMax I/O Station to a Genius I/O bus. The system host can be any PLC or
computer capable of controlling the Genius bus.
E
SHIELD OUT
SERIAL B2
SHIELD IN
SERIAL A2
SHIELD OUT
SERIAL B1
SHIELD IN
SERIAL A1
0
1 0
0
7
6 4 5
8
9 1
1
BAUD
RATE
SBA
X10
3
2
3
2
3
2
GBI001
BUS B
SBA ERR
I/O ENBL
FORCE
PWR
FAULT
OK
SBA
X1
IND CONT EQ FOR HAZ LOC
CLASS I DIV 2 GROUPS ABCD
Ambient 60C
CLASS I ZONE 2 GROUP IIC
Ex nA II 0C<To<60C
Ex nV II
Demko No. 98Y 125014
MADE IN USA
THIS DEVICE COMPLIES WITH PART 15 OF
THE FCC RULES. OPERATION IS SUBJECT
TO THE FOLLOWING CONDITIONS:
1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE.
2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
THIS DIGITAL APPARATUS DOES NOT
EXCEED THE CLASS A LIMITS FOR RADIO
NOISE EMISSIONS FROM DIGITAL APPARATUS
SET OUT IN THE RADIO INTERFERENCE
REGULATIONS OF THE CANADIAN DEPART-
MENT OF COMMUNICATIONS. FOR USE IN
A CONTROLLED ENVIRONMENT. REFER TO
MANUALS FOR ENVIRONMENTAL
CONDITIONS.
ENCAD D'UTILISATION EN ATMOSPHERE
CONTROLEE. CONSULTER LA NOTICE
TECHNIQUE.
U
N
A
N
Genius ® NIU
IC200GBI001
The Network Interface Unit installs on a 35mm x 7.5mm conductive DIN rail. A
VersaMax power supply module mounts directly on the righthand side of the NIU.
LEDs on the lefthand side indicate the presence of power and show the operating
mode and status of the NIU. Three rotary dials beneath a clear protective door are
used to configure the NIU’s address on the Genius bus and to set its
communications baud rate. Removable connectors are used to install single or
redundant bus cables. These connectors make it possible to disconnect a bus cable
from the NIU without breaking the continuity of the bus, so other devices on the
same bus can continue operating.