Fluke 45 - Manual (Page 3)

Safety Class
This is an IEC safety class 1 (grounded enclosure) product. For safety, the ground wire
in the line cord must be connected when operating from AC power.
When operated from the optional battery pack, this product meets the safety
requirements for a safety class 2 (reinforced insulation) product and does not require
grounding for safety.
Interference Information
This equipment generates and uses radio frequency energy and if not installed and used
in strict accordance with the manufacturer’s instructions, may cause interference to radio
and television reception. It has been type tested and found to comply with the limits for a
Class B computing device in accordance with the specifications of Part 15 of FCC Rules,
which are designed to provide reasonable protection against such interference in a
residential installation.
Operation is subject to the following two conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including interference that may
cause undesired operation.
There is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of more of the following measures:
•
Reorient the receiving antenna
•
Relocate the equipment with respect to the receiver
•
Move the equipment away from the receiver
•
Plug the equipment into a different outlet so that the computer and receiver are on
different branch circuits
If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions. The user may find the following booklet prepared
by the Federal Communications Commission helpful: How to Identify and Resolve
Radio-TV Interference Problems. This booklet is available from the U.S. Government
Printing Office, Washington, D.C. 20402. Stock No. 004-000-00345-4.
Declaration of the Manufacturer or Importer
We hereby certify that the Fluke Model 45 Dual Display MultiMeter is in compliance with
BMPT Vfg 243/1991 and is RFI suppressed. The normal operation of some equipment (e.g.
signal generators) may be subject to specific restrictions. Please observe the notices in the
users manual. The marketing and sales of the equipment was reported to the Central Office
for Telecommunication Permits (BZT). The right to retest this equipment to verify compliance
with the regulation was given to the BZT.