Fujitsu Siemens Computers LOOX 400 - Manual (Page 60)

Troubleshooting and tips
52 A26391-K150-Z120-1-7619, Edition 3
The information on the display of the Pocket PC is difficult to
read
Reflection
►
Turn the Pocket PC until you can see the information in the display again.
The Pocket PC switches off
If you operate the Pocket PC too long with only the battery, the Pocket PC switches into the
Suspend mode when the battery charging level is too low.
►
Connect the PSC11R-050 power adapter to charge the battery.
► Press the Suspend/Resume button.
The Pocket PC does not start after switch on
If the Pocket PC does not start after switch on, this may be due to one of the following:
The battery is dead
►
Charge the battery.
► Connect the PSC11R-050 power adapter to the cradle with the Pocket PC.
► Check whether the PSC11R-050 power adapter is connected correctly to the cradle.
► Check whether the power cable is plugged properly into the power adapter and into the mains
outlet. The indicator on the power adapter should illuminate.
The battery is charged. The power-on indicator flashes green.
PSC11R-050 power adapter is not properly connected
►
Switch the Pocket PC off.
► Check whether the PSC11R-050 power adapter is properly connected to the Pocket PC and
the electrical outlet.
► Then switch the Pocket PC on again