Furuno FAR2167DS-BB - Manual (Page 21)

1-14
Changing the cable entrance on control unit RCU-015/RCU-016
To change the cable entrance from the side (default) to the bottom, modify the unit as shown
below.
Changing cable entrance on control unit RCU-015/RCU-016
Cable clamp
03-163-7804
Screw M3X8
(torque: 10.78 Nm)
Screw M4X8
(torque: 1.47 Nm)
2. Pull out cable.
1. Remove cable
clamp.
3. Pass cable thru this hole.
4. In here, clamp copper part
of cable with cable clamp
removed at step 1.
J522: Plug in here to connect RCU-016 in series with RCU-015.
Bottom of unit