Furuno FAR2167DS-BB - Manual (Page 70)

4-15
5. Attach the DVI-RGB CONVERSION board to the location shown below.
Fixing the DVI-RGB conversion board inside the processor unit
6. Attach the 10-pin connector from J1 on the 03P9229B board to J9 on the DVI-RGB board.
7. Attach the connector assembly 03-2092 to J4 on the DVI-RGB CONVERSION board.
8. Remove connector housing J615 from the 03P9342 board. Connect the cable from J3 on the
03P9229B board and the cable from J4 on the DVI-RGB CONVERSION board to J615. Attach
J615 to the 03P9342 board.
To connect wires to the WAGO connector, use the terminal opener (supplied as installation
materials) as shown below.
Connecting wires to the housing
9. Connect the DVI cable to J3 on the DVI-RGB CONVERSION board. Connect the end that does
not have the ferrite core.
10.Pass an RGB cable (local supply) through the cable clamp and connect it to J2 on the
03P9229B board.
11.Pass the DVI cable through the cable clamp, laying the section with copper tape in the cable
clamp.
12.Assemble the processor unit and connect the other end of the DVI cable to the DVI-D port.
J4
DVI-RGB
CONVERSION board
J9
J3 (Connect DVI cable at step 9.)
1) Press downward.
2) Insert core.
J615 Housing
Terminal opener
RED
YEL
GRN
ORG
1
2
3
4
5
BRN