Furuno FAR2167DS-BB - Manual (Page 44)

3-3
6. For Control Unit RCU-014:
a) While pressing and holding down the [HL OFF] key, press the [MENU] key five times.
b) Press the [0] key to show the INITIALIZE menu.
For Control Unit RCU-015:
See the procedure on the next page for how to show the INITIALIZE menu.
INITIALIZE menu
7. RCU-014: Press the [2] key to open the ECHO ADJ menu.
RCU-015: Choose 2 ECHO ADJ and then push the thumbwheel.
ECHO ADJ menu
8. RCU-014: Press the [3] key to choose HD ALIGN.
RCU-015: Choose 3 HD ALIGN and then push the thumbwheel.
9. RCU-014: Key in the bearing difference. The setting range is 0 to 359.9(°).
RCU-015: Spin the thumbwheel to set the bearing difference and then push the thumbwheel.
The setting range is 0 to 359.9(°).
10.Confirm that the target echo is displayed at correct bearing on the screen and then push the
thumbwheel.
11.RCU-014: Press the [MENU] key to finish.
RCU-015: Left-click the MENU box to finish.
[INITIALIZE]
1 BACK
2 [ECHO ADJ]
3 [SCANNER]
4 [INSTALLATION]
5 [OWN SHIP INFO]
6 [ARP PRESET]
7 [NETWORK]
8 [OTHER]
[ECHO ADJ]
1 BACK
2 CABLE ATT ADJ
AUTO/MANUAL
30
3 HD ALIGN
000.0 °
4 TIMING ADJ
0
5 MBS
0
6 DEFAULT ANT HEIGHT
5/7.5/10/ 15 /20/
25/30/35/40/45/
more 50 m
7 NEAR STC CURVE
2/2.5/ 3 /3.5
8 MID STC CURVE
3/ 4 /5/6
9 FAR STC CURVE
6/ 7 /8
0 RING SUPPRESSION
0