Furuno FAR2167DS-BB User Manual

Page 29

Advertising
background image

2-6

4. In the order shown in the figure below, pass the gland nut, flat washers (3 pcs.) and gasket onto

the power cable.

5. As shown in the figure below, fold back armor onto flat washer and insert it thru the other flat

washer. Cut off part of armor that protrudes past flat washer..

Passing flat washer, etc. onto HV cable

6. Pass the power cable though its cable gland and then tighten the gland nut..
7. Pass the power cable to the rear of the antenna unit.

Antenna unit, left-side view

8. Connect the power cable to its terminal, referring to the interconnection diagram.
9. Close the cover.
10.Seal the cable gland for the power cable with putty.

25 mm

5 mm

FV2

Sheath

Armor

Vinyl sheath

230 mm

(1)

Flat washer

(2) (3)

Cut off armor that
protrudes past washer.

Gasket

Power cable

Gland nut

Cable gland for power cable
(TPYCY-2.5)

Terminal for power cable

Advertising