FUJITSU M5000 - Manual (Page 121)

Chapter 6 Storage Devices Replacement 6-29
6.3.6 Removing the Tape Drive Backplane of the M4000
Server
1. Remove the CD-RW/DVD-RW Drive Backplane.
This step includes removing the CD-RW/DVD-RW Drive Unit and the
CD-RW/DVD-RW Drive Backplane. See
Section 6.2.7, “Removing the
CD-RW/DVD-RW Drive Backplane of the M4000 Server” on page 6-18 .
2. Remove the tape drive unit from the server and place it on the ESD mat.
See Section 6.3.2, “Removing the Tape Drive Unit” on page 6-26 .
3. Remove the power cable (p4) from the tape drive backplane.
4. Disconnect the blue serial cable from the tape drive backplane.
5. Loosen the captive screw that holds the tape drive backplane (TAPEBP) in place
and lift the tape drive backplane (TAPEBP) from the guide pins and place the
backplane on the ESD mat.
6.3.7 Installing the Tape Drive Backplane of the M4000
Server
1. Place the tape drive backplane (TAPEBP) onto the guide pins.
2. Tighten the captive screw that holds the tape drive backplane (TAPEBP) in
place.
3. Connect the blue serial cable to the tape drive backplane.
4. Connect the power cable (p4) to the tape drive backplane.
Caution – Do not force any components into server slots. Doing so can cause damage
to the component and server.
5. Install the tape drive.
See Section 6.3.3, “Installing the Tape Drive Unit” on page 6-27 .
6. Install the CD-RW/DVD-RW Drive Backplane.
This step includes installing the CD-RW/DVD-RW Drive Backplane and the
CD-RW/DVD-RW Drive Unit. See
Section 6.2.8, “Installing the CD-RW/DVD-RW
Drive Backplane of the M4000 Server” on page 6-19 .