Garland STW286A - Manual (Page 12)

Part # 4517957 Rev. 13 (02/10/11) Page 12
3. If ignition fails and or the ignition system goes into
lockout, set the power switch to the “O” position.
4. Wait five minutes and repeat steps 1 and 2. If a problem
persists have the unit checked by a competent
technician.
Shut Down
1. Set the thermostat to the lowest setting and turn the
power switch to the “O” position.
OPERATION continued
Operating Suggestions
1. Turn the power switch to the “O” position when the range
is not in use.
2. Clean the range as soon as possible after cooking tomato
or vinegar based products that have a high acid content.
These foods can cause pitting of the surface.
3. Allow the oven to preheat before adding product.
4. During an electrical power interruption, turn the power
switch to the “O” position. The oven cannot be made to
operate without electrical power
MAINTENANCE & CLEANING
Regular servicing by a competent person is recommended
to ensure the continued safe and efficient performance of
the appliance. The frequency will vary, depending on the
installation conditions and usage. Usually once per year is
adequate.
WARNING: Turn off the gas supply to the appliance at the
service cock and the electrical mains before commencing
any servicing work.
IMPORTANT: Test for gas leakage on completion of any
servicing work.
A regular cleaning schedule should be established to ensure
efficient operation.
WARNING: This appliance is not protected against water
jets. Do not clean with water jets.
Stainless steel
Stainless Steel should be cleaned using a mild detergent,
a soft cloth and hot water. If it is necessary to use a non-
metallic scouring pad, always rub in the direction of the grain
in the metal to prevent scratching. Wash a small area at a
time and rinse the washed area with a clean sponge dipped
into a disinfectant and wipe dry with a soft clean cloth before
it can dry.
Use only stainless steel, wood or plastic tools to scrape off
heavy deposits of grease or oil. Do not use ordinary steel
scrapers or knives as particles of iron my become embedded
and rust. NEVER USE STEEL WOOL.
Exhaust Filter
Inspect the front exhaust filter weekly, if on inspection the
filter appears dirty it can be cleaned by hand with hot water
and dish detergent. The filter is easily removed by sliding out
of the lower front panel of the unit.
Enameled/Painted Surfaces
Establish a regular cleaning schedule. Any spills should be
wiped off immediately. The unit should be allowed to cool
down before cleaning any exterior surfaces. Wipe exposed
cleanable surfaces when cool with mild detergent and
hot water. Stubborn residue spots may be removed with a
scouring pad. Dry thoroughly with a clean cloth.