Garland STW286A - Manual (Page 19)

Part # 4517957 Rev.13 (02/10/11) Page 19
6. Replace the control and reassemble in the reverse order.
Front Cooling Fan
1. Remove fastener securing the control compartment
access panel.
2. Slide out the control drawer.
3. Disconnect the fan supply harness form the unit wiring
harness.
4. Remove fasteners retaining the fan and set aside.
5. Replace the faulty motor.
6. Reassemble in the reverse order.
Motor
1. Open the oven doors.
2. Remove the oven racks and guides.
3. Remove the two (2) wing screws securing the fan guard
and remove the guard.
4. Using an allen head wrench loosen the screw securing
the blower wheel to the motor shaft and remove the
wheel.
5. Remove the four (4) screws securing the motor mount
plate to the oven casing back and pull the plate forward
into the oven compartment.
6. Disconnect the motor wire connections (note which wire
connects to which) and replace faulty motor.
8. Reassemble in the reverse order.
REPLACEMENT OF PARTS continued
Ignition Control
1. Remove the fastener securing the control compartment
access panel.
2. Slide out the control drawer to access the lamp.
3. Disconnect the supply wires to faulty ignition control
(noting the wire connections)
4. Replace the faulty control.
6. Reassemble in the reverse order.
Hot Top Ignition Momentary Switch
1. Remove the griddle grease drawer.
2. Remove the fasteners securing the front panel.
3. Remove the nuts securing the switch box to the front
panel.
4. Disconnect the 2 wires to the switch.
5. Unscrew the switch from the front panel.
6. Replace the switch and reassemble in reverse order.
Hot Top Spark Generator
1. Remove the fastener securing the control compartment
access panel.
2. Slide out the control drawer to access the generator
module.
3. Disconnect the wires to the generator.
4. Remove fastener retaining the generator.
5. Replace the faulty module and reassemble in reverse
order.