GE UX-CL 220 User Manual
Page 88
Sending a Fax From Memory
86
Memory transmission
You can also send a fax through memory when sending to a single
destination. This is convenient when sending to destinations where the line is
often busy, as it saves you from waiting to pick up the original document and
frees the feeder for other operations.
6
When you are ready to begin transmission, press
.
•
A Transaction Report is automatically printed out after Broadcasting is
completed. Check the "Note" column of the report to see if any of the
destinations are marked "Busy" or have a communication error code. If so,
send the document to those destinations again.
START/MEMORY
To send a fax through memory, load the document, press
, and then
dial using one of the following methods:
♦
Press the number keys to enter the fax number and then press
.
♦
Press
repeatedly to select an auto-dial number and press
.
♦
Press
once to select the last number dialed and press
.
START/MEMORY
START/MEMORY
START/MEMORY
START/MEMORY
If the memory becomes full...
If the memory becomes full while the document is being scanned, MEMORY
IS FULL and SEE MANUAL will alternately appear in the display.
♦
Press
if you want to transmit the pages which have been stored up
to that point in memory. The remaining pages will be ejected from the
feeder. After transmission, the memory will be cleared and you can transmit
the remaining pages. You will also need to transmit the page which was
being scanned when the memory filled up.
♦
Press
if you want to cancel the entire transmission.
START/MEMORY
STOP