MITSUBISHI ELECTRIC WS-48513 - Manual (Page 19)

18 19
Connecting a Single Analog Antenna, Wall Outlet Cable
Cable Box
Figure 4
1. Connect the incoming cable to ANT-A on the TV back
panel.
Note: Connect two coaxial cables as follows:
2. One from LOOP-OUT on the TV back panel to IN on the
cable box back panel.
3. One from OUT on the cable box back panel to ANT-B
on the TV back panel.
Single Antenna or Wall Outlet Cable for
Analog Broadcasts
Figure 3
For antennas with twin flat lead
1. For antenna with twin flat leads, connect the 300-Ohm
twin leads to the 300-Ohm to 75-Ohm transformer.
2. Push the 75-Ohm side of the transformer onto ANT-A
on the TV back panel.
Note: 300-Ohm to 75-Ohm matching transformers
are not provided with the TV. They should be
available at most electronic stores.
For cable or antenna with coaxial lead
3. Connect the incoming cable to ANT-A on the TV back
panel.
300 Ohm Flat
Twin Lead
Optional 300 Ohm to 75 Ohm
Matching Transformer
75 Ohm
Coaxial Cable
1
2
3
TV back panel (section detail)
IR EMITTER
NetCommand REPEATER
Incoming
Cable
1
OUT
Cable Box
back panel section
IN
2
3
TV back panel (section detail)
Additional connection cables are
not provided with the TV. They are
available at most electronic stores.
IMPORTANT
Note: Net Command® assumes that your Cable Box
is connected to Ant-B and your VCR. Also, Channel
3 is the default output channel for the Cable Box. If
either the connections or output channel are different,
use the Change option of Edit NetCommand to apply
the changes.
Figure 3. Connecting Antenna or Wall Outlet Cable for
Analog Broadcasts
Figure 4. Connecting a Cable Box
Mitsubishi strongly recommends against using
antennas with twin flat leads. Twin flat lead antenna
wires are subject to interference which may
adversely affect the performance of the TV. We
recommend using coaxial antenna cable.
Connecting a Cable Box