MITSUBISHI ELECTRIC WS-48513 - Manual (Page 53)

52 53
NetCommand ® Controlled Recordings
Record To Setup
Figure 4
Your TV is able to start and stop recordings automatically
and send the signals from one external playback device
to another external recording device. It is also able to
convert digital signals from Antenna DTV and from IEEE
1394 devices to analog signals that can be recorded
on NetCommand compatible analog VHS and S-VHS
VCRs. You cannot record from an analog device such as
Antenna A, Antenna B or a VHS or S-VHS VCR to a digital
recording device such as a D-VHS VCR or A/V Disc.
You can schedule the recording to take place at a later
time and program the recording duration, in 30 minute
increments, to last from 30 minutes to 6 hours.
When a digital recording is being made, the TV will direct
the signals to the recording device using the IEEE 1394
cable. During the recording the TV is able to watch any
analog source or can be turned off.
When an analog recording is being made, the TV will
direct signals to the recording device using the stereo’s
left and right audio for Audio Video 1 of Monitor Output.
During the analog recording, the TV can be powered Off.
If the TV is powered On, it must be tuned to the source
that is being recorded.
If the Monitor outputs are sent through the A/V Receiver
to a recording device, then the A/V Receiver must be
turned on and set to the TV input.
Recording Now
While viewing Antenna A, Antenna B, Antenna DTV, an
IEEE 1394 device, or a non-recording traditional device,
you can start recording now.
To initiate recording now:
1. Press REC (record) on the TV remote.
2. Press DEVICE on the remote control to select the
source device choices that you can record from.
3. Press ADJUST or to select the source device you
will record from.
4. Press ENT(er) to confirm selection and return to the
“Record to” section.
5. In the “Record to” section, review the destination
device (VCR1) and duration. Change if necessary.
6. Press REC a second time to initiate recording.
Time-Delayed Recording
To initiate a time-delayed recording:
1. Press REC (record) on the TV remote.
2. Press DEVICE on the remote control to move to the
Source Device section.
3. Press ADJUST or to select the source device you
will record from.
4. Press ENT(er) to confirm your Record from selection
and move to the Record to section.
5. Press ADJUST or to select the Record to device,
duration time, start time (press ENT(er) after selecting
hour, minutes and am or pm to set the time) and
day. For devices that can select channels, select the
channel.
6. Select Add and press ENT(er) to add the recording
to the record list. If your selection is successful a
confirmation message will be displayed. If you pick
overlapping times, day(s), or destination devices, you
will see a message stating there is a conflict.
7. To exit, press HOME on the TV remote after all
recordings have been added.
Figure 4. Record to screen