MITSUBISHI ELECTRIC WS-48513 - Manual (Page 95)

94 95
IMPORTANT
For further assistance, call
(800) 332-2119.
The instructions below will lead you through the Diamond
Shield removal process for models WS-48513, WS-48613,
WS-55513, WS-55613, WS-65513, WS-65613 and
WS-73513. The Diamond Shield for these models comes
installed by the factory.
You will need to remove:
(2) molding clips
(1) Diamond Shield™
1. Remove the side clips by pressing them out of the
opening, starting at a corner. Do not force the clip.
The clip will slide out of place.
2. Remove the shield, sliding it out of the channels,
starting with the top guide. Gently bow the Diamond
Shield™ toward you and push the side of the Diamond
Shield™ out of the channel then remove the opposite
side.
3. Wipe off any dust with a lint-free cloth and store the
screen carefully where it will not be scratched. This
completes the Diamond Shield™ removal.
4. Re-install the molding clips for a finished look.
To install the Diamond Shield™, reverse the order of the
above process.
Appendix G: Diamond Shield™ Removal for Models
WS-48513, WS-48613, WS-55513, WS-55613, WS-65513, WS-65613 and
WS-73513
WARNING
Sharp edges! Always wear gloves to
handle, lift, remove and install Diamond
Shield and molding clips.
Step 1. Diamond Shield molding clip removal
Step 2. Diamond Shield removal