MITSUBISHI ELECTRIC WS-48513 - Manual (Page 96)

96 97
The instructions below will lead you through the
Diamond Shield installation process.
Included in the Diamond Shield package are the
following items:
For models WS-55813, WS-65713, WS-65813 and
WS-73713
(1) Diamond Shield™
(2) molding clips
1. Carefully remove the Diamond Shield™ from the
protective packaging. Wipe off any dust with a lint-
free cloth. Do not use any cleaners on the anti-glare
Diamond Shield™.
2. Begin by inserting the shield, sliding it into the
channels, starting at the bottom. Gently bow the
Diamond Shield™ toward you and insert the top of
the Diamond Shield™ into the top channel.
3. Install the left and right molding clips by pressing
them into the opening, starting at a corner. Do not
force the clip. The clip will slide into place. This
completes the Diamond Shield™ installation.
To remove the Diamond Shield™, reverse the order of
the above process.
Appendix G: Diamond Shield™ Installation for Models
WS-55813, WS-65713, WS-65813 and WS-73713
WARNING
Sharp edges! Always wear gloves to
handle, lift, install and removeDiamond
Shield and molding clips.
Step 1. Diamond Shield installation
Step 2. Diamond Shield molding clip installation